請問,不要用431,光偶用什么IC 好做點,目前這樣的IC能做多大W ,用這類IC有什么不好的地方
請問,不要用431,光偶用什么IC 好做點,目前這樣的IC能做多大W ,用這類IC有什么不好的地方
全部回復(10)
正序查看
倒序查看
@samsonsu
1:除了電壓精度不好搞啊..?還有什么其它的問題?有什么好IC好推薦的?我現在是做小W的10W,15w,兩路輸出,三路輸出..需要考慮那些難題啊,體積,成本,,,,?2:對于多路輸出這一點,有那些方面要注意啊?各位幫我出下好的建議啊謝謝啊
兄弟,首先你的問題很矛盾,多路電源是不可能不用431,光偶的,
多路電源一般采用一路主受控(一般為輸出功率較大的那一路),其它各路再去按電壓輸出的高低,及功率大小平均分配..
對于成本的要求是相對的,看你的電源要求指標了,交叉調整率的精度等等.
多路電源一般采用一路主受控(一般為輸出功率較大的那一路),其它各路再去按電壓輸出的高低,及功率大小平均分配..
對于成本的要求是相對的,看你的電源要求指標了,交叉調整率的精度等等.
0
回復
@yj-power
兄弟,首先你的問題很矛盾,多路電源是不可能不用431,光偶的,多路電源一般采用一路主受控(一般為輸出功率較大的那一路),其它各路再去按電壓輸出的高低,及功率大小平均分配..對于成本的要求是相對的,看你的電源要求指標了,交叉調整率的精度等等.
thanks for your suggestion
as you know .from above description , I would like to design less than 18W with two type of output voltage,not DVD power.
so like this type of power . the cost is to be condsidered first . but not effects basic function . that `s why I mention this requriment.you think illogicality problem ,
as you know .from above description , I would like to design less than 18W with two type of output voltage,not DVD power.
so like this type of power . the cost is to be condsidered first . but not effects basic function . that `s why I mention this requriment.you think illogicality problem ,
0
回復